Magnetic Inlays: Mini electromagnets for wireless charging
Micro drilling is reliable
“The magnetic components that are state of the art today are often wound by hand in low-wage countries. With our know-how from printed circuit board production, we can not only manufacture thinner components but also significantly improve reliability,” says Gerald Weidinger, who heads development at AT&S. Instead of winding an actual wire around an iron core, the windings are realized with the finest of holes around a tiny ring of special magnetic materials that have been embedded in circuit board material.
“We drill through the core of the circuit board inside and outside the ring, the holes are then plated with copper and connected with traces below and above the magnet ring. This creates an embedded electromagnet,” says Weidinger. With this technology, thousands of such elements can be produced in parallel on a single panel. This also enables automated quality control, which contributes to the superior reliability of the magnetic elements.
Small is beautiful
AT&S is currently working on perfecting the technology for customers. By expanding the possible performance ranges, additional applications are to be opened up. In addition to smaller wireless chargers and more efficient power supply circuits, the technology is also being expanded to make tiny electromagnets in shapes other than the toroids described above. Magnetic layers inside a printed circuit board can also be used to shield sensitive electronic circuits from each other.